A-A-55095A
2.2 Sizes The coveralls shall be furnished in the following sizes:
Length
Sizes
Extra Short
34
36
38
40
42
Short
34
36
38
40
42
44
46
Regular 34
36
38
40
42
44
46
48
50
52
54
Long
36
38
40
42
44
46
48
50
52
54
Extra Long
36
38
40
42
44
46
48
50
52
54
Extra Extra Long
36
38
40
42
44
46
48
50
52
54
3. SALIENT CHARACTERISTICS
3.1 General Description. The coverall (see figures 1 and 2) shall have long sleeves with adjustable
cuffs; two breast pockets with flaps, two hip pockets; one with a flap and one without a flap; two front
patch pockets without flaps; a two piece upper back with a single pleat in each panel at the waistband,
a waistband with belt loops, a pencil slot in the left breast pocket flap, a convertible collar, and a double
slider slide fastener fly front. The left front facing shall be finished with a continuous line of stitching
through the front starting at the neck and terminating at the crotch seam (J-stitch) catching both slide
fastener tapes. The right front facing shall be finished with a continuous line of stitching through the front
starting at the neck and terminating at the crotch seam. The neck shall be closed under the collar with a
button and buttonhole (see figure 3). When coverall is in a fully closed position (buttoned, snapped, and
zipped), the collar/neckline apex shall meet at the center front. A gripper type snap fastener shall secure
the fly front just above the top of the slide fastener tape and centered between scoops of the slide
fastener and the finished edge. The coverall shall have a hanger loop with a 2-inch free opening
positioned inside the back neck.
3.1.1 Pockets. The coverall shall have six pockets, one pocket on each breast with sewn-down flap
covering the top of the pocket, the left breast pocket flap shall have a pencil slot (see figure 4), one
pocket on each leg front, caught in the waistband with side of the pocket caught in side seam and one
pocket on each back panel just below waistband. The left hip pocket shall have a sewn-down flap
covering the top of the pocket. The front patch pockets (lower front pocket) shall have a 6 (+1/8) inch
opening. The breast and hip pockets shall have a 1 (+1/8) inch top hem.
3.1.2 Belt loops. The coverall shall have five belt loops located as follows: one on each side seam, one
on the center back seam, one centered on each front lower pocket. The belt loops shall finish 2-
1/2(+1/8) inches long and ½ (+1/16) inch wide. Belt loops shall be double stitched not less than ¼ inch
gage. The belt loops shall be attached by laying the belt loop flat and folding under the top and bottom.
The belt loops shall be bartacked at the top and bottom. The bartacks shall be 1/16 to 1/8 inch from
folded edge. The belt loop shall lay flat after attaching to the coverall. There shall be no fullness under
the belt loop.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business