A-A-52115C
B. Measure down front from shoulder seam at collar to bottom edge of sweater. C. Measure across neck opening from shoulder seam to shoulder seam of collar.
D. Measure along folded edge of left front yoke seamline at bottom to collar seamline at top. E. Measure along folded edge of sleeve, from the intersection of the armhole seam and
shoulder seam to the bottom edge of the cuff.
F. Measure from the intersection of the armhole section and shoulder seam at top on a
straight line to the intersection of the armhole and inseam at bottom.
G. Measure on a straight line across center, from folded edge to folded edge.
H. Measure across width of sleeve from folded edge to sleeve seam at a point 10 inches from
bottom of armhole along sleeve seam.
1/ The tolerances from the armhole lengths and sleeve length shall be consistent. A plus tolerance in one measurement and a minus tolerance in another will not be permitted.
3.5 Weights. The weight of the finished sweaters shall be as specified in Table IV, and tested in accordance with ASTM-D-3776.
TABLE IV. Weight (pounds)
Weight/dozen |
X-Small |
Small |
Medium |
Large |
X-Large |
XX-Large |
(minimum) |
9 |
10-1/2 |
12 |
13-1/2 |
15 |
16-1/2 |
4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
5. QUALITY ASSURANCE PROVISIONS
5.1 Product conformance. The products offered shall meet the salient characteristics of this commercial item description, conform to the producer's own drawings, specifications, standards, and quality assurance practices, and be a similar product that is offered for sale in the commercial market. The Government reserves the right to require proof of such conformance.
5.2 Market acceptance criteria. The item offered, or a generic equivalent, must have been sold to the commercial market or to the Government.
5.3 Visual examination. The sweater shall be examined for the defects listed below.
5.3.1 Defects. Barre; any hole, cut, tear, color not as specified; any spot or stain (outside); raw edges; open seams; thread ends not removed; loose tension resulting in loose seams; any material defects; any repairs; distorted parts or poor workmanship; any component part omitted; label missing, incorrect, or illegible; measurement of item not as specified; bar code omitted or not readable by scanner; human-readable interpretation (HRI) omitted or illegible; bar code not visible on folded, packaged item; bar code causes damage to the item; any items not packaged in accordance with the contract or purchase order.
5.4 Acceptance criteria. Acceptance criteria shall be as specified in the contract or purchase order.
6. PACKAGING
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business