A-A-52115C
3.2.4 Tape reinforcement. The tape for reinforcing the shoulders and the bottom of the armhole shall be a plain weave cotton, 1/2 + 1/32 inch in width, 35 pounds minimum warp strength, and 58 pounds minimum filling yarns per inch. The tape shall be dyed to approximate the shade of the knitted fabric.
3.3 Label. Each sweater shall have a combination size, identification and instruction label for garments, made of either nonwoven, spunbound polyester or nonwoven, 80/20 polyester/cellulose cloth. The label shall be coated with an acrylic coating that does not contain skin irritants, toxic materials or materials that support mildew growth. The label shall show "good" colorfastness to accelerated laundering, and shall contain the following information:
SWEATER, MAN'S, OD
FIBER CONTENT: 100% ACRYLIC
CONTRACT NUMBER
NSN
SIZE
NAME OF CONTRACTOR
LAUNDERING INSTRUCTIONS:
WASH IN WARM WATER 80 + 5oF, KNIT CYCLE.
TUMBLE DRY, LOW HEAT, REMOVE PROMPTLY.
DO NOT USE CHLORINE BLEACH.
3.3.1 Label/tag. Each item shall be individually bar-coded with a pressure-sensitive label or paper tag. The finish of the label/tag shall be compatible with printing technology used. The label/tag shall be readable by a scanner. The bar coding element shall be a 13 digit national stock number (NSN), and shall be located so that it is completely visible on the item when it is folded and/or packaged as specified.
3.4 Finished measurements. The finished sweater shall conform to the measurements specified in Table III.
TABLE III. Finished measurements (inches)
NOTE: Refer to Figure 1 for measurements A through H. The sweater shall be fully buttoned and placed smooth and flat.
A. Measure across front, approximately 1 inch below armhole seams, folded edge to folded edge.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business